We professionally supply high quality hose and fittings.

ShIP to

Preventive Maintenance For Hydraulic Hose Fittings

by:Yober     2020-05-26
Every mechanical part needs maintenance, so do the Hydraulic hose fittings. Obviously, correct maintenance can keep mechanical products under good conditions. Otherwise, the improper maintenance may lead since problems which should cause more serious problems. Therefore, for you to do some preventive maintenance to avoid some unnecessary failures. The preventive repair off the Hydraulic hose fittings involves many steps. It is warned that taking care or repair procedures should be done after disconnecting the pump from the actual supply. The following are some things related with the preventive maintenance of the Hydraulic hose features. First of all, you should check the hydraulic fluid levels. Proper oil level is 1/2 against the top of the fill hole when all wrenches are retracted. You must check the oil level in the reservoir regularly. May should drain, flush, and refill the reservoir with high-grade hydraulic oil following a certain period people. Secondly, the cleaning maintenance is an important procedure for the preventive maintenance. Under this step, you seal all unused couplers with thread protectors, and keep all hose connections free of dirt and grime and the pump's outer surface as free from dirt as possible. Besides, the equipment connected to the pump must be placed clean. Thirdly, you should drain and flush the reservoir. On the pump interior is removed from the reservoir, you should clean the pump exterior. There are some things to track. Remove the ten screws fastening the motor and pump assembly to the reservoir. You must ensure that you do not damage the gasket or bump the filter or pressure regulating valves when lifting the pump and motor off the reservoir. Clean the inside of the reservoir and fill with suitable flushing oils. Place the pump and motor assembly back onto the reservoir, and secure with two machine screws assembled on opposite corners of industry. After then, it is run the pump for several or so minutes. Then disconnect the motor and pump assembly, and drain and clean the associated with the reservoir. At last, really fill the reservoir with Hydraulic hose fittings. Place the pump and motor assembly on the reservoir, and thread the ten anchoring screws. In addition to the above mentioned steps, the oil should be added in to the reservoir. Before doing this, wrench must be fully retracted and the ability supply should be disconnected. You should clean the entire area around the filler plug pail nearby the filler plug, and use on a clean funnel with filter when adding oily fat.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...